I am very happy to have it as a second/backup system and will likely use it more often than my main system, but that's only because it lets me brew while still being a parent. If anything I would expect my Foundry batches to be more consistent because I'm not trying to fine tune the burner to adjust the boil off. I've only brewed once on my Foundry and that batch is still carbonating so I can't speak to the finished quality, but I can't think of any reason the quality would be lower than with my propane setup. I would have gone with High Gravity, Brew Boss, or SS Brewtech 1V setup or wait to see if their FTSS will be that higher quality all in one 1 was looking for. If i were to do it again i would have gotten a higher quality setup from the start, but i like you thought this would be my inclement weather only setup and would brew a lot more on my traditional system. If it had to be an all in 1, i would go with Grainfather but at that price point i might as well go with a non all in 1 electric that is somewhat more traditional. The Anvil is the new kid on the block and unknown what their issues will be. Does not help that there have been main board issues on the Robobrew V3 that have me thinking they are a ticking time bomb. I am about 15 batches in and feel this way. If you brew a lot, the fit finish and robustness of the all in one may not be worth it in the long haul. The anvil looks better as it has more perforated surface area that might address the stuck sparge issue and not have to crush grain so coarse which would fix the efficiency issues.Ĥ) Dont underestimate the getting what you pay for. Mainly repeatability of efficiency, hitting targets, and managing stuck sparges. I am looking at a upgraded all electric system at the moment as i think the Robobrew has some limitations that frustrate me at times to be consistent. I only use it about 10% of the time for 10 gallon high volume easy drinking summer beers but find myself using my all in 1 (Robobrew) setup most of the time. Note: Grainfather and Turbo 500 Boiler sold separately.For reference i was a cooler batch sparger on outdoor propaneġ) I love it, but it did take a few batches to dial in crush and recirc/lauter to workĢ) Not at all, simply adjusted to match the nuances of the new setupģ) Not as much i i thought i would, i find that once i dialed in my indoor setup i rarely go back to the old outdoor setup as it was different. The large copper surface area of this dome top acts as a catalyst with the vapor in the still and helps enhance and concentrate the flavors and aromas as well as remove unwanted sulfur compounds. This can be used in place of the T500 Boiler's stainless steel lid. The Pot Still Alembic Dome Top is copper and fits on to your T500 Boiler or Grainfather G30. This comes with a thermometer, tubing and tap adaptor set. It is what retains the flavor rather than stripping it out by refluxing. This condenser is what differentiates this still from the T500. You can use this with the T500 Boiler without the Pot Still Alembic Dome Top, to do this it fits on to the lid of the T500 Boiler. The Pot Still Alembic Condenser is best used with the T500 Boiler and the Pot Still Alembic Dome Top. Instead of stripping flavors to produce a clean distilled product like the T500, this pot still retains and enhances flavors. Copper Dome Top w/ Alembic Copper Condensor additions transform the T500 or Grainfather G30 into an Alembic Pot Still.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |